Category: Support-TurnMill

Support - Software

8/5/2020

CAMplete TurnMill V9 Build 195 has been made available for all TurnMill customers up to date on maintenance.

Added customization of the decimal precision for FANUC IS-C specifications
Added support for simulating polar milling with full radius compensation.
Improved the accuracy of the 'Zoom To Mouse' mode when using the mouse wheel to change the zoom point.
Improved Mastercam operation mapping for side milling cycles.
Fixed an issue with Gibbs GCI files for duplicate points
Fixed an issue with Gibbs GCI files for upper sub milling arc directions.
Fixed an issue with Gibbs imported arcs converted to point milling.
Fixed an issue where post processing of certain canned cycles with varying hole depths was not using the correct tilted plane calculation for repeated holes.
Fixed an issue with C-axis rotations for B-axis machines at -90 for certain processing modes.
Added support for .WRL file formats.

6/22/2020

CAMplete TurnMill V9.0.192.R5 NC Format has been made available for all TurnMill customers up to date on maintenance.

Added program parameter to control cutting feed rate decimal place precision.
Added support for posting full radius compensation.
Added program parameter support for controlling coolant.
Update user cycle templates for post processing.
Modified milling approach rotary C axis position prior to X, Y, Z axis position for customers using the face parameter to control the C axis approach by plane.
Add posting support for G32 thread cycle